Cheshire Cat Computing

I have Routers2 version 2.15 installed and working for the most part except that it appears that my Directory[] options within my MRTG config files are being ignored.

When I try to open a target I receive an error stating that the RRD file could not be found. The path it gives to the RRD is simply the WorkDir defined in the MRTG config file. As stated above it appears as the Directory[] target option is being ignored and Routers2 is not looking in the respective subdirectory of the WorkDir. Config verification is all correct except for the RRD files being listed as "Unable to read..."

Is there some conf file setting I'm missing to enable support for the per target Directory[] options? I really do not want to put all my RRDs in one directory as I have thousands of them.

Other CGI frontends do not have a problem with my configs or the Directory[] options. I have 14all.cgi working correctly as well as Drraw.cgi.

The support for Directory was added in 2.14 and fixed in 2.15, so (to the best of my knowledge) it works. Can you email or post the cfg file(s) in question so that I can check and make some tests using v2.16b7 ?

Steve

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11

Ok per your e-mail suggestion I have reordered my config file so that all target[xxx] at least appear before their respective directory[xxx] option. Now all the RRDs are being seen and read correctly.

Your parser has also shown me some mistakens I've made that were not apparent in the other frontends I've used. A good thing but just more clean up... argh.

Thanks for your help!