Cheshire Cat Computing

We current have threshold set for CPU utilization and also for bandwidth utilization. The alerting works fine for both, but the graphs display "funny". For the cpu utilization I have:
ThreshMaxI[target]: 75
This displays correctly on the graph as 75%
For wan links I have:
ThreshMaxI[target]: 60%
Again the alerting works correctly, but my graphs are wrong. On a t3 link with maxbytes set to 5526250, the graphs show a threshold of around 3 meg. The exact number escapes me at the moment.
This was with 2.16 beta5. I put 2.16 beta6 on today, and now for anything with a % I don't see the threshold line at all.
Is there any way to fix this?

Hmm, beta 6 may have broken it. Can you post the relevant portions of the cfg file? I will test this when the office opens again on Tuesday. Thanks for the notification...

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11

YLegend[target-cpu]: Percentage CPU load
ShortLegend[target-cpu]: %
Directory[target-cpu]: target
Legend1[target-cpu]: Avg 1 min CPU Utilization in %
Legend2[target-cpu]: Avg 5 min CPU Utilization in %
LegendI[target-cpu]:  Avg 1 min CPU Load:
LegendO[target-cpu]:  Avg 5 min CPU Load:
WithPeak[target-cpu]: ywm
MaxBytes[target-cpu]: 100
Options[target-cpu]: integer, gauge, nopercent
Unscaled[target-cpu]: dwmy
ThreshMaxI[target-cpu]: 75
ThreshProgI[target-cpu]: /opt/mrtg-2.10.15/bin/cpu.pl

The cpu utilization still works correctly, and always has when graphed.

Target[target_1]: 1:community@target:
SetEnv[target_1]: MRTG_INT_IP="xx.xx.xx.xx" MRTG_INT_DESCR="Serial3/0"
Directory[target_1]: target
MaxBytes[target_1]: 5526250
ThreshDesc[target_1]: Interface Serial3/0
ThreshMaxI[target_1]: 60%
ThreshProgI[target_1]: /opt/mrtg-2.10.15/bin/bandwidthin.pl
ThreshMaxO[target_1]: 60%
ThreshProgO[target_1]: /opt/mrtg-2.10.15/bin/bandwidthout.pl
Title[target_1]: Serial3/0

This one now doesn't display a threshold line at all, or the legend for it in the graph. The previous version I had (2.16beta5 showed the line, but appeared to have the wrong value. It would show the line at I think about 3.2 mb/s, where I would expect ~26.5mb/s.

The only configuration change I made between the two version is I added:
optimise = yes
I have changed it back to no and it still doesn't display.

_________________
Steve Shipway
UNIX Systems, ITSS, University of Auckland, NZ
Woe unto them that rise up early in the morning... -- Isaiah 5:11