| Cheshire Cat Computing http://steveshipway.org/forum/ |
|
| How to Generate Incoming/Outgoing Graphs for ifErrors http://steveshipway.org/forum/viewtopic.php?f=2&t=4946 |
Page 1 of 1 |
| Author: | mmartin [ Wed Nov 30, 2011 10:37 am ] |
| Post subject: | How to Generate Incoming/Outgoing Graphs for ifErrors |
| Author: | stevesh [ Sun Dec 04, 2011 8:32 am ] |
| Post subject: | Re: How to Generate Incoming/Outgoing Graphs for ifErrors |
Instead of this: routers.cgi*Graph[$target_name]: All-Errors active put this: routers.cgi*Graph[$target_name]: All-Errors-in active noo routers.cgi*Graph[$target_name]: All-Errors-out active noi This creates two userdefined graphs, one holding the incoming errors and one the outgoing errors. You might also like to add some customisations for the labelling. routers.cgi*ShortDesc[All-Errors-in]: Incoming Errors routers.cgi*Title[All-Errors-in]: Incoming Errors for my router ... and so on. |
|
| Author: | mmartin [ Fri Dec 09, 2011 3:18 am ] |
| Post subject: | Re: How to Generate Incoming/Outgoing Graphs for ifErrors |
Steve, Hey thanks for the reply. Oh good idea...! I didn't think to go that route of using a UserDefined Graph. I'm assuming that Routers2 recognizes what "Unit" your using and if it's for Traffic then it automatically creates the Incoming and Outgoing graphs. Thanks again and good idea! Matt |
|
| Page 1 of 1 | All times are UTC + 12 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|