| Cheshire Cat Computing http://steveshipway.org/forum/ |
|
| Howto limit graph when using "Factor[...name...]: -100000" ? http://steveshipway.org/forum/viewtopic.php?f=2&t=1591 |
Page 1 of 1 |
| Author: | babydr [ Thu Jul 10, 2008 10:59 am ] |
| Post subject: | Howto limit graph when using "Factor[...name...]: -100000" ? |
I was hoping that "routers.cgi*LowerLimit[...name...]: 1000" would help when the graph is really a HUGELY negative . Like this graph mo-rtr01.cfg-_mo-rtr01_1I-IE-m-x2.png :-} . Tia , JimL |
|
| Author: | stevesh [ Sun Jul 13, 2008 12:32 am ] |
| Post subject: | Re: Howto limit graph when using "Factor[...name...]: -100000" ? |
| Author: | babydr [ Thu Jul 17, 2008 10:16 am ] |
| Post subject: | Re: Howto limit graph when using "Factor[...name...]: -100000" ? |
routers.cgi*LowerLimit[]: -200000 routers.cgi*UpperLimit[]: 512000 routers.cgi*Options[]: rigid I started placing these line at the Combined graph (ie: mo-rtr01_1I-IE) and the graphic is 'trimmed' at the very bottom of it's lowest point , But not at my selected cutoff value . I then proceded to set them at each level above that , with the same effect . ie: at the mo-rtr01_1 , mo-rtr01_1IE config points . Heck I have even tried setting the cutoff value to -1 . With no other effect to the graphic than the trimming mentioned previously . Tia , JimL |
|
| Author: | stevesh [ Thu Jul 17, 2008 11:09 am ] |
| Post subject: | Re: Howto limit graph when using "Factor[...name...]: -100000" ? |
Hmm, this doesnt sound quite right. I have to admit I've not really done any testing with negative factors and so its quite possible this is borken. The LowerLimit does work with positive values (this is tested) but with a negative factor it seems all bets are off, I'll need to do more investigation 
|
|
| Page 1 of 1 | All times are UTC + 12 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|