| Cheshire Cat Computing http://steveshipway.org/forum/ |
|
| Support for ^ in cfg? http://steveshipway.org/forum/viewtopic.php?f=11&t=776 |
Page 1 of 1 |
| Author: | Rednarb [ Thu Dec 29, 2005 1:34 pm ] |
| Post subject: | Support for ^ in cfg? |
| Author: | Rednarb [ Fri Dec 30, 2005 12:08 pm ] |
| Post subject: | |
I took out all the prefixes and just did it "normally" and Routers2 then began to read it fine. So I guess the answer is "no". Shame too, using the prefixes really saves a lot of repeats. |
|
| Author: | stevesh [ Fri Dec 30, 2005 10:13 pm ] |
| Post subject: | |
The ^ and $ (and _) targets are generally supported by routers2. However, support for the Directory[] directive cannot support them correctly. You should be able to use all the other prepend/append directives OK. Let me know if there are specific ones that don't work. The historical reason for all this is that back when routers2 was first written, I had to write my own parser as there was no MRTG perl library available. Subsequently Tobi added all sorts of new directives (such as Directory[] ) which were hard or impossible to support with my parser. As a result, we will need to wait until version 3.0 before the parser is completely redone to use the MRTG library. |
|
| Page 1 of 1 | All times are UTC + 12 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|